![background image](http://html1.mh-extra.com/html/weigh-right/pmb-1/pmb-1_instruction-manual_952475005.webp)
block the top of the machine. The height of the machine, which can be adjusted with
threaded leveling feet, is usually determined by the method by which the bags are filled.
Manual filling will require the machine to be set at a comfortable height for the operator.
Automatic filling processes because of the way they operate, usually require the
machine to be set at a pre-engineered height, based.on conveyors and other pieces of
equipment.
GETTING STARTED
Height adjustment of the machine is accomplished by loosening (but not
removing) the four leveling feet on either side of the main machine chassis.
Move the machine to the desired height and tighten the lock nuts. Make sure it is level
before tightening the bolts all the way.
THE MACHINE IS TOP HEAVY! DO NOT LOOSEN THE LEVELING FEET
UNTIL PROVISIONS HAVE BEEN MADE TO SUPPORT THE MACHINE WHEN
IT IS OFF OF THE GROUND. MAKE SURE A 1” MINIMUM OF THREAD IS
LEFT IN THE THREADED FRAME POST.
CONNECTION OF AIR AND POWER
The main air filter regulator assembly is attached to the right rear
corner of the machine. The regulator has a
1
A~ NPT port for the
plumbing of the air supply. Connection can be made with either a quick connect
nipple or hard plumbed with a hose fitting.
THE AIR SUPPLY TO THE MACHINE IS FITTED WITH A SUPPLY CUTOFF
DEVICE. IN THE EVENT OF AN EMERGENCY SITUATION THIS DEVICE
WILL BE NECESSARY TO DISCONNECT THE MACHINE FROM THE MAIN
AIR SUPPLY.
The machine comes equipped with a standard 3 prong male 120 volt line cord.
Uncoil the cord and straighten it out. On the front left corner of the machine, locate
the
EMERGENCY STOP
switch. Make sure the switch is depressed, which is the
off position. Plug the cord into an acceptable outlet as outlined in set up section on
power requirements.
The footswitch assembly comes equipped with a 3 pin cable. Locate the receptacle
align the pins and push the plug into the receptacle.
The machine is now ready to be loaded with product and adjusted for use. Before
proceeding further, read and understand the next section. It deals with the controls
of the machine and how to use them.
Содержание PMB 1
Страница 23: ......