17
41
37
74
49
49
83
Rod
Ball
Large tabs
must be on
this side
4
95
95
41. Identify the Ab Cable (83); it is approximately
220.40” long and it has a ball on one end and a
loop on the other.
Wrap the Ab Cable (83) around a 90mm Pulley
(37). Place two Pulley Covers (49) over the
Pulley;
make sure that the large tabs are in the
position shown.
Attach the Pulley and Pulley
Covers to the Butterfly Upright (4) with an M10 x
100mm Bolt (91), two M10 Washers (95), and an
M10 Nylon Locknut (74).
Be sure that the Cable
is between the Pulley and the rod on the
Upright, and that the ball is on the side
shown.
42. Remove the two 90mm Pulleys (37) from the
Double “U”-Bracket (42). Wrap the Ab Cable (83)
around a Pulley. Reattach the Pulley to the
Double “U”-Bracket with an M10 x 45mm Bolt
(96) and an M10 Nylon Locknut (74).
43
96
37
44
83
43
74
43. Wrap the Ab Cable (83) around the other 90mm
Pulley (37) removed in step 38. Reattach the
Pulley and Cable Trap (44) to the bottom set of
holes in the Pulley Plates (43) with an M10 x
45mm Bolt (96) and an M10 Nylon Locknut (74).
Be sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
44
83
74
Bracket
1
37
96
44. Wrap the Ab Cable (83) around a 90mm Pulley
(37). Attach the Pulley and a Cable Trap (44) to
the bracket on the Butterfly Base (1) with an M10
x 45mm Bolt (96) and an M10 Nylon Locknut (74).
Make sure the Cable Trap is oriented as
shown.
42
74
96
42
83
37
91
44
