40. Insert the Press Seat Frame (36) into the Frame
(80). Attach the Press Seat Frame with a 3/8” x
2 1/4” Carriage Bolt (8) and the 3/8” Knob (105).
The Press Seat Frame can be attached at any of
four heights.
41. Attach a Backrest (39) to the Frame (80) with two
1/4” x 2 1/2” Bolts (94) and two 1/4” Flat Washers
(40).
42. Make sure that there are two 5” Grips (25) on the
Lat Bar (96). If there are not, wet the ends of the
Lat Bar with soapy water, and slide a Grip onto
each end.
13
40
41
42
8
36
14
15
80
105
94
94
39
80
40
40
96
25
25
20
21
24
72
70
2
24
24
22
72
5
Lubricate
24
43
19
17
18
16—Lubricate
18
18
17
19
28
13. Tap two 1 3/4” x 1 3/4” Inner Caps (24) into the
Squat Arm (72).
Tap two 1” Round Caps (22) into the Squat Arm
(72).
14. Lubricate a 3/8” x 3 1/4” Bolt (5). Attach the Squat
Arm (72) to the VKR Upright (70) with the 3/8” x
3 1/4” Bolt and a 3/8” Jam Nut (2). Do not over-
tighten the Jam Nut; the Squat Arm must pivot
freely.
15. Tap two 1 3/4” x 1 3/4” Inner Caps (24) into the
upper end of the Press Arm (28).
Attach a Rubber Bumper (20) to the Press Arm
(28) with a #8 x 1/2” Tap Screw (21).
Make sure that there are two 3/4” Flange
Bushings (18) in the indicated holes in the Base
(43). Press two 3/4” Flange Bushings (18) into the
indicated holes in the Press Arm (28).
Apply lubricant to the 3/4” x 8 1/2” Axle (16). Align
the bottom of the Press Arm (28) with the 3/4”
Flange Bushings (18) in the Base (43). Slide the
Axle into the Press Arm and Base. Tap a 3/4”
Retainer (17) and a 3/4” Retainer Cap (19) onto
each end of the Axle. Note: The teeth on the
Retainers must bend toward the Retainer Cap
as shown in the inset drawing.
16
9
17
19
16
