18
38. Locate the Leg Press Cable (99). Attach the
end of the Leg Press Cable to the Long “U”-
Bracket (57) with an M8 Nylon Locknut (3)
and an M8 Washer (8). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable only a
couple of turns, as shown in the inset
drawing.
Wrap the Leg Press Cable (99) around a
90mm Pulley (15). Attach the Pulley to the
Leg Press Upright (56) with the M10 x 95mm
Bolt (88), an M10 Washer (9), and an M10
Nylon Locknut (21). The ball on the Cable
must be on the indicated side of the
Pulley. Be sure that the Cable and Pulley
move smoothly and that the Cable is
between the Pulley and the welded rod.
39. Attach the Press Bracket (94) to the Leg
Press Arm (96) with an M10 x 75mm Bolt
(111) and an M10 Nylon Locknut (21).
Wrap the Leg Press Cable (99) around a
90mm Pulley (15). Attach the Pulley to the
Press Bracket (94) with the M10 x 50mm Bolt
(12) and an M10 Nylon Locknut (21).
Slide an M8 Washer (8) onto an M8 x 75mm
Bolt (93). Insert the Bolt through the lowest
hole in the Rear Seat Frame (100) from the
indicated side. Note: The three holes are for
cable adjustment. Tighten an M8 Nylon
Locknut (3) onto the Bolt. Slide the end of the
Leg Press Cable (99) onto the end of the Bolt.
Thread another M8 Nylon Locknut onto the
Bolt. Do not fully tighten the second
Locknut. There must be room between the
two bolts for the end of the Cable to pivot.
39
CABLE ASSEMBL
Y
93
111
96
94
12
21
100
3
8
21
99
15
38
56
57
Ball
9
21
15
3
88
3
8
57
99
99
Welded
Rod
8
