13
24. See the inset drawing. Attach a 90mm Pulley
(15) and a Cable Trap (66) to the upper hole in
a Long “U”-Bracket (57) with an M10 x 50mm
Bolt (12) and an M10 Nylon Locknut (21). Be
sure that the Cable Trap is inside the Long
“U”-Bracket. Note: This may come pre-
assembled.
Route the High Cable (58) through the Long
“U”-Bracket (57) and around the 90mm Pulley
(15) shown in the inset drawing. Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
25. Wrap the High Cable (58) around a 90mm
Pulley (15). Attach the Pulley to the bracket on
the Top Frame (55) with an M10 x 50mm Bolt
(12) and an M10 Nylon Locknut (21). Be sure
that the Cable is in the groove of the Pulley
and that the Cable and Pulley move
smoothly.
26. Note: This assembly step shows how to
complete the assembly of several pre-
attached parts.
The 15mm Spacer (7) has been pre-attached
ton the Press Frame (17) for shipping purpos-
es. Remove the M10 Nylon Locknut (21), the
Spacer, and the 90mm Pulley (15) from the
M10 x 95mm Bolt (88). Do not remove the
Bolt; the Bolt has been shown removed for
part identification.
Slide the 15mm Spacer (7) back onto the M10
x 95mm Bolt (88).
24
58
15
15
66
21
12
57
Bracket
55
21
12
15
58
25
26
CABLE ASSEMBL
Y
58
57
21
17
15
7
9
88
