Weh TW57, Руководство по эксплуатации

Страница: 8 / 60

1�4 General safety instructions
Î
Always comply with all applicable local, national and international requirements,
stipulations, decrees, laws, standards, provisions, directives, norms, regulations,
prohibitions and instructions as well as all applicable industrial, quality and technical
standards. In particular, make sure that you and all users comply with the applicable
requirements related to occupational health and safety as well as product safety
requirements and that all required permissions, certificates and approvals have been
obtained.
Î These operating instructions should be provided to anyone responsible for the
installation, operation and maintenance of this WEH
®
Product.
Î Contact WEH before using the WEH
®
Product if the instructions in these operating
instructions are unclear in any way.
Î
Take appropriate safety measures if operating conditions exist that could endanger
the user.
Î In case of any damage that may affect the proper functioning of the WEH
®
Product, do
not use the WEH
®
Product until the situation has been clarified. Disassembly of the
WEH
®
Product may only be performed by WEH.
Î Comply with the assembly data indicated in these operating instructions. Tightening
with higher torques/assembly turns can result in damage or even fractures when the
system is pressurized.
Î
Do not use any auxiliary materials or cleaning agents other than those indicated in
these operating instructions. Using other auxiliary materials or cleaning agents may
cause damage to the WEH
®
Product or to downstream components.
- WEH is not responsible for damage caused by external forces or other external
influences.
- It is assumed that only transport and storage facilities suitable for the storage of the
WEH
®
Product are used.
- If you use accessory parts – such as swivel joints, for example – designed for a
higher pressure range than the WEH
®
Connector, you must make sure that the
pressure range remains within the valid range for the WEH
®
Connector.
- If gas escapes unintentionally from the cylinder valve
( Figure 1 ), these venting bores in the WEH
®
TW57
Connector will direct the gas away to the side and prevent
an unwanted build-up of pressure in the equipment.
Attention: Do not block or obstruct the drill holes!
Figure 1
MD-10058-L51-R1.1.0-03
Page 8
Operating instructions AE