Wegener DTV742, Руководство пользователя

Страница: 20 / 50

DTV 742 User’s Manual
800057-01 Rev. B 20 wegener.com
Perform the DTV742 and PC IP Setups as shown in Table 4 and Table 5.
Addresses other than those listed may be used if they are compatible. Consult
your network administrator if you have questions.
LAN
Connection For LAN connection, attach the DTV742’s Ethernet port to the LAN using a
normal RJ-45 cable (8 pins). Set the DTV742 IP Address, Netmask, and Gate-
way as directed by your network administrator. Use any PC on the LAN to
connect to the DTV742 using the web browser instructions below.
NOTE: Each unit on the network must have a unique address.
3.3 Web Browser Control
Getting
Started To begin monitor and control functions from a PC or LAN connection:
a) Open the current internet browser of your choice from the local PC or
computer on the LAN attached to your DTV742.
b) Set the browser's address field to http://nnn.nnn.nnn.nnn where
nnn.nnn.nnn.nnn is the IP address of the unit to be controlled (set from
the DTV742’s front-panel, IP Address screen).
NOTE: For IP addresses which include subfields with leading zeros, you must
omit those zeros when entering the address in your browser. For example, IP
address 128.092.050.004 must be entered as 128.92.50.4.
The DTV742 Control and Status screen will appear. You may also select either
the Stream Info, Unit Configuration, Config In, Config Out (1 through 4), or
Q&A/Help pages at any time by clicking their respective tabs at the top of the
screen. The following paragraphs detail the use of each of these pages.
Table 4: DTV742 IP Setup
Parameter Setting
IP Address 172.016.100.020
Netmask 255.255.000.000
Gateway 000.000.000.000
Table 5: PC IP Setup
Parameter Setting
IP Address 172.016.100.001
Subnet Mask 255.255.000.000