Weco WF-107, Инструкция по эксплуатации, Страница: 12 / 32

Cod.006.0001.1260
10/07/2017 v2.14
ENGLISH
WF-107
12/32
8.1 LOCKING PROCEDURE
The procedure inhibits unit adjustments, allowing the user to modify only certain settings depending on the selected lock status.
The procedure is used to prevent accidental alteration of the unit settings and welding settings by the operator.
Enabling
If no locking status is selected (LOC = OFF) and if you wish to set up a limitation on use of the power source, display the LOC function in the
SETUP menu.
Open the Setup menu.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
E1
Select the following setting with the encoder: LoC
E2
Use the encoder to select the required lock status.
E1
Select the following setting with the encoder: ESC
S1
Press any button to save the setting and quit the menu.
Tab. 3 - Functions not disabled by Locks
LOC USER INTERFACE RC03 RC04 RC05 RC06
oFF
All adjustments enabled.
Key K1 disabled.
All adjustments enabled. All adjustments enabled. All adjustments enabled. All adjustments enabled.
1
Selection of torch trigger procedure (button S5)
Display of main welding parameters (button S1)
Arc correction (encoder E2)
Wire insertion (button S2)
Gas test (button S3)
Arc correction
(Potentiometer Pot2)
Arc correction (UP/DOWN
lever 2)
2
Selection of torch trigger procedure (button S5)
Display of main welding parameters (button S1)
Arc correction (encoder E2)
Synergy (encoder E1)
Wire insertion (button S2)
Gas test (button S3)
All adjustments enabled. All adjustments enabled. All adjustments enabled. All adjustments enabled.
3
(*1)
Selection of torch trigger procedure (button S5)
Display of main welding parameters (button S1)
JOB selection (encoder E2)
Wire insertion (button S2)
Gas test (button S3)
Scroll JOBS (UP/DOWN
lever 1)
Scroll JOBS (UP/DOWN
lever 1)
*1: The LOC 3 setting becomes active only when a JOB is loaded. When no JOB is loaded, the user interface is completely unlocked.
Disabling
If a lock status is selected, you can only edit parameters permitted by the currently active lock status.
Open the Setup menu.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
E1
Select the following setting with the encoder: LoC
E2
Select the following setting with the encoder: oFF
E1
Select the following setting with the encoder: ESC
S1
Press any button to save the setting and quit the menu.