Weco WF-107, Инструкция по эксплуатации, Страница: 10 / 32

Cod.006.0001.1260
10/07/2017 v2.14
ENGLISH
WF-107
10/32
7 RESET (LOAD FACTORY SETTINGS)
The reset procedure involves complete restoration of the default values, parameters and memory settings set in the factory.
Too many changes made to the welding parameters so user finds it difficult to restore defaults.
Unidentified software problems that prevent the welding power source from functioning correctly.
7.1 TOTAL RESET
The reset procedure involves complete restoration of the default values, parameters and memory settings set in the factory.
All memory locations will be reset and hence all your personal welding settings will be lost!
Set the welding power source ON/OFF switch to “O” to switch the unit off.
S2 S6
Hold down both buttons simultaneously.
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SIMULTANEOUS ACTIONS
rEC FAC The message appears on the following displays: D1-D2
Exit without confirmation
Press any button (except S4).
This action will automatically close the menu.
Exit with confirmation
S4 Press the button.
This action will automatically close the menu.
Wait for the memory clear procedure to terminate.
7.2 PARTIAL RESET
The reset procedure involves restoration of the parameter values and settings, except the following settings:

settings of the SETUP menu

saved JOBS
Set the welding power source ON/OFF switch to “O” to switch the unit off.
S2 S6
Hold down both buttons simultaneously.
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SIMULTANEOUS ACTIONS
rEC FAC The message appears on the following displays: D1-D2
E2 Select the following setting with the encoder: rEC PAr
Exit without confirmation
Press any button (except S4).
This action will automatically close the menu.
Exit with confirmation
S4 Press the button.
This action will automatically close the menu.
Wait for the memory clear procedure to terminate.