Weco Discovery 200 S, Инструкция по эксплуатации

Страница: 7 / 14

Discovery 200 S
Cod.006.0001.1320
22/05/2019 v2.8
ENGLISH
7/14
3 COMMISSIONING
3.1 USER INTERFACE
CODE SYMBOL DESCRIPTION
L1
This LED illuminates to confirm the presence of power on the output sockets.
L2
Overheating alarm
Indicates tripping of the welding power source thermal protection.
Leave the unit running so that the overheated components cool as rapidly as possible.
When the unit has cooled, the welding power source will reset automatically.
- Make sure that the power required by the welding process is lower than the maximum rated power output.
- Check that the operating conditions are in compliance with the welding power source data plate specifications.
- Check for the presence of adequate air circulation around the welding power source.
L3
This LED illuminates to show that the following welding mode is selected: MMA
L4
This LED illuminates to show that the following welding mode is selected: PULSED DC TIG
L5
This LED illuminates to show that the following welding mode is selected: TIG DC CONTINUOUS
L6
This LED indicates that the current reference setting is imposed by the user interface.
L7
This LED indicates that the current reference setting is imposed by the remote controller.
S1
This button selects the welding mode.
S2
The button enables the device to receive the welding current control signal from a remote controller.
POT1
MMA: The potentiometer sets the value of the following parameter:
HOT START
TIG: The potentiometer sets the value of the following parameter:
PULSED CURRENT FREQUENCY
POT2
MMA: The potentiometer sets the value of the following parameter:
ARC FORCE
TIG: The potentiometer sets the value of the following parameter:
BASE CURRENT
POT3
The potentiometer sets the value of the following parameter: WELDING CURRENT