3
ENGLISH
Installation Options
Vehicle Installation Option
1 . Attach the Mounting Bracket to the
vehicle’s dashboard .
• Clean the area where the bracket is
to be mounted with the alcohol wipe
included . Allow the area to dry .
• Peel the backing to expose the adhesive
and press the bracket onto the desired
location on the dashboard . NOTE: Be
sure the tab is positioned vertically .
• Allow the adhesive to cure for 24
hours before you attach the Drive
AS100
(Step 4) .
2 . Install the Outside Antenna . Select a
location on top of the car that is:
• Near the center of the vehicle’s roof .
• At least 31cm from any other antennas .
• Free of obstructions .
• At least 16cm from any windows
(including sunroofs) .
The Outside Antenna must be installed
vertically .
3 . Run the Outside Antenna cable into the
car . The cable is strong enough that it
may be shut in most vehicle doors without
damaging the cable . For a cleaner look,
carefully pull down the door seal, run the
cable under the seal, and push the seal
back into place . This method reduces wear
on the cable as the door opens and closes .
4 . Attach the Drive
AS100
to the Mounting
Bracket . After waiting 24 hours for the
adhesive on the bracket to cure, attach the
Drive
AS100
by aligning the rectangular
hole on the back of the Drive
AS100
with
the tab on the Mounting Bracket, grasping
the sides of the Drive
AS100
, and sliding it
downward approximately 6mm into place .
The Mounting Bracket is designed to
swivel for more convenient viewing angles .
Once the Drive
AS100
is in place, you
can adjust the angle of the bracket by
loosening the knurled nut, applying gentle
pressure to the top or bottom of the Drive
AS100
, and then tightening the nut when
the desired angle is achieved .
5 . Attach the antenna to the Drive
AS100
.
Connect the cable from the Outside
Antenna to the antenna connector on the
bottom of the Drive
AS100
. Do NOT plug
in the power supply (next step) until the
Outside Antenna cable is connected to
the Drive
AS100
.
Note: The Drive
AS100
has a convenient
mini-USB charging port located on
the right side of your booster . This
port allows for charging your phone
or device . WeBoost offers several
cables for this purpose
• mini-USB to mini-USB
• mini-USB to iPhone (up to 4S)
• mini-USB to micro-USB
