Weber mt CR 9-II, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 32

16 CR 9-II CCD 2.0
2
4
5
1
2
3
Control the direction of travel with the drive lever (1).
Only run machine within reach of the guide bar.
The green LED (2) will be illuminated as soon as the
operating frequency has been reached, indicating that
the COMPATROL
®
compaction measurement system is
ready for operation.
During the compaction work, compaction is continuously
measured and displayed visually via the yellow
LEDs 1 – 7 (3). Maximum possible compaction is reached as
soon as there is no noticeable increase in the illuminated
LEDs.
If all LEDs (2 + 3) are illuminated then compaction must be
stopped immediately.
Maximum compaction is achieved.
It is possible to loosen the material that will be compacted.
If the substrate is too hard, the possibility of machine
damage cannot be excluded.
If the red and green LEDs (4 + 5) light up, the material cannot
be compacted. The substrate should be replaced with
material that can be compacted.