CR 9-II MDM
15
1
3
2
4
5
6
7
8
10
9
Insert the ignition key (1) and turn to position 1.
10 hours prior to the next scheduled maintenance the LED (2)
lights up permanently.
The operating hours until the next maintenance will be
displayed.
Turn the ignition key (1) to position 2.
Release the ignition key as soon as the engine starts.
The ignition key must return to pos. 1 and remain in this
position during operation. The charge level (3), tempera-
ture (4), air filter (5) and oil pressure indicator (6) must
go out immediately after starting.
The LED indicator (7) is continuously illuminated, indicating
that the engine is in operation.
The operating hours counter (8) will keep counting the
operating hours as long as the ignition is switched on.
If the ignition key does not spring back to pos. 1 – turn
off the machine immediately – danger of starter damage
due to the starter also running during operation.
Start for a maximum of 20 seconds without interruption.
If the engine does not start, repeat start procedure after
one minute. If the engine does not start after two start
procedures, look for the cause in the fault table.
Compacting
Bring the gas lever (9) into full-throttle position.
Control the direction of travel with the drive lever (10).
Only run machine within reach of the guide bar.
