Webasto BlueHeat Thermo Top, Руководство пользователя

Страница: 14 / 32

14
Ford F-250/350 Super Duty Truck
Coolant Hose Connections - 6.4 Liter TT Diesel
Cut supplied hoses as shown in Figure 22.
Hose A: From engine to coolant pump inlet - Connect the
90° end to the coolant pump at the Webasto heater.
Hose B: From Webasto heater outlet to vehicle heater
core inlet - Connect the 90° end to the heater outlet.
ATTENTION
Install metal conduit on coolant hoses prior to
installation.
Connect 90° end of hose “A” to Webasto heater coolant
pump.
Connect 90° end of hose “B” to Webasto heater outlet.
Route coolant hoses above the inner fender splash shield
to the engine compartment.
– (A) Webasto heater inlet hose
– (B) Webasto heater outlet hose
– (1) Hose clamp - 2ea.
– (2) Coolant pump
– (3) Metal conduit
ATTENTION
Confirm supply and return hoses to vehicle heater
core before cutting any coolant hoses. Once
confirmed, cut supply hose, leaving sufficient hose
for connections.
Cut the heater core supply hose approximately 3 in. from
the 90° bend in hose. Rotate supply hose toward the
right side of the vehicle. See Figure 24.
Route the Webasto heater outlet hose “B” over to the
heater core supply hose (90° section) and trim to proper
length.
Connect the Webasto heater outlet hose “B” to the
heater core supply hose with coolant adapter and two
hose clamps.
Route the Webasto heater inlet hose “A” to heater core
supply hose (engine side) and trim to proper length.
Connect the Webasto heater inlet hose “A” to the heater
core supply hose with coolant adapter and two hose
clamps.
– (1) Heater core supply hose
– (A) Webasto heater inlet hose, adapter, and two
clamps
– (B) Webasto heater outlet hose, adapter, and two
clamps
Fig. 22
Discard
Discard
A
B
Fig. 23
B
2
3
1
1
A
Fig. 24
1
B
A