1
http://support.weathermatic.com
1.0 Installing the Aircard
1.0 Installing the SmartLink Flow Aircard
1.
Verify that the version of SmartLine controller you are
connecting this Aircard to is compatible. This can be
done through the “Advanced Menu” of the SmartLine
controller. Only versions 3.1 and higher are compatible.
2. Remove the SmartLink Flow Aircard’s accessory bag
from the box. This contains the mounting screws, and
antenna.
3. Before mounting to the wall, screw the
antenna firmly into the bottom of the
Aircard.
4. There are 2 cables leaving the bottom
of the Aircard. Locate the cable on
the left with the clear RJ-11 connector
on the end. This is the Aircard cable
and will need to be run up through the
bottom of the SmartLine controller
case. You may need to widen an
existing hole using a drill or punch out
the area indicated on the bottom.
5. Plug the Aircard cable into the RJ-11
jack located inside the controller. If the controller has
two RJ-11 jacks (SL4800), either jack will work. The jack
is located in the upper right area, and is black. Ensure it
is plugged in completely.
6. Verify that all of the nearby cables are put neatly
in place, which will enable the panel door to close
completely.
7. The Aircard status LED will flash rapidly green until
it cycles through the 4 status positions. This will last
approximately 15-30 seconds.
8. Take note that on the outside of the Aircard’s box and
on the right side of the Aircard itself is a label printed
with the 19- digit ID number.
This is specific to this Aircard
and will be needed to activate
and register your Aircard on the
SmartLink Network.
9. If you have not yet activated and registered your
Aircard, see Step 2 – Setting up your SmartLink
Network Account to activate. You will need the 19-digit
ID number.
10. If you have already activated the Aircard, the Aircard
status LED will remain a solid green light once
communication is established. If, after activation on
the SmartLink Network, the status LED continues to
flash red, please contact the Help Desk. http://support.
weathermatic.com
LTE
