WeatherBug Weather Station, Инструкция по установке, эксплуатации и обслуживанию

Страница: 36 / 39

Weather Station Manual
AWS-WXN-60003.001 Version 1.0, Release 5 November 2004
- 36 -
Calibration
If your WeatherBug Weather Station is properly installed, only the time and barometric
pressure will need to be calibrated. The barometric pressure sensor must be adjusted to
compensate for altitude differences between the WeatherBug factory and your installation
site. The weather station time is typically pre-set to US Eastern Standard Time (EST). All
other calibration is performed prior to shipment.
The WeatherBug Weather Station is designed for remote calibration by WeatherBug via the
Internet. WeatherBug must properly configure your weather station for remote access to
enable remote calibration.
In most cases, depending on your location, WeatherBug will already have access to an
accurate local barometric pressure reading. Call WeatherBug to find out. If WeatherBug does
not have a local barometric pressure reading for your area, you must obtain an accurate local
reading from your National Weather Service office and/or television station before
WeatherBug can calibrate the pressure accurately.
Part of the equation for barometric pressure is elevation. WeatherBug has already entered
your general elevation and has fine-tuned this if you have sent your data in. However, we still
require a local reading to ensure that the calibration agrees with other local data.
WeatherBug Technical Support:
800-624-4205
support@aws.com
Monday - Thursday -- 8:00am-7:00pm EST
Friday -- 8:00am-5:00pm EST