HD MotionCam
Installation Manual
EN.PM.UM24 20160211
-17-
Page 17 of 29
Note: The HD MotionCam Ethernet Cable is not UV rated. Cable must
be routed in conduit when running outdoors to protect it. The cable
should be run inside as much as possible. Cable can be run in ceiling
spaces.
Routing the Cables
It is best to work with a team of at least two people, as cable will have to be handled from
both the inside and the outside of the building.
Keep in mind the standard HD MotionCam package contains 200 feet of Ethernet cable.
These cables must reach from the camera to the corresponding network connection.
1.
With the end of the cable as close as possible to the network and power
connections that will be used, and allowing about eight extra feet, tape the end of
the cables to something sturdy in the area to hold it in place, keeping in mind that
the cables cannot run directly across the floor and will have to be attached to areas
such as the base of walls when the job is complete.
2.
Run the cable to the general area that the camera will be mounted outside; fish
tape may be used here to make this step easier.
3.
Tape the cable down as close to where the camera will be mounted as possible,
keeping in mind the cable will need to be run through the mounting arm for the
camera.
4.
At the outside location where the camera is to be mounted, as close to the camera
as possible, install conduit to cover any outside portion of the cables. Make sure
the cables will reach through the mounting arm to where the camera will be
mounted.
