RACK ASSEMBLY
STEP 1
Silicone Application:
Apply a minimum of 2 beads of silicone (Part N) around all swages. If there is a hole,
silicone should be applied on either side of the hole. Silicone should also be applied
around the outer hole surfaces where the bolt and the washer touch the tube.
Install End Caps (Part Q) onto both cross members and rear arms.
STEP 2
Assembly Recommendation:
1) If user plans on carrying ladders, it is recommended to reverse the carriage bolts to have the bolt head on the inside of the rack.
2) Before applying protective strip, make sure cross members are clean and clear of any debris.
STEP 3
Identify the driver side and passenger side front arms by locating the biased side joint plate.
The driver side front arm joint plate will be biased to the left (driver side) with the weld also on the left side.
Attach the driver side rear arm to the front arm using (3) Part D, (3) Part L, and (3) Part F.
REAR CROSS MEMBER
REAR DRIVER’S
SIDE ARM
INSIDE
OUTSIDE
REAR VIEW – DRIVER SIDE
REAR VIEW – PASSENGER SIDE
INSIDE
OUTSIDE
3
©2019 WernerCo
