background image

ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS

BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.

TRUCK STORAGE SOLUTIONS

SECURING YOUR REPUTATION

WEATHERGUARD.COM

WEATHERGUARD.COM

INSTALLATION MANUAL

PROTECT R L

®

 

ROT

R

WEATHERGUARD.COM

STEE

PACK RAT

®

 DRAWER UNITS

MODEL

 CAUTI

To keep debris out of your eyes when checking the underside of the vehicle, or 
when drilling, always wear protective eyewear. Never load your rack to exceed 
the safe rated capacity of your vehicle. Heavy loads carried high can 
dangerously alter the center of gravity.

ON

Note:

 

 X represents the color code for your model: 0 = Clear  

|  

3 = White  

|   

5 = Black  

|

  52 = Matte Black

1175-X-02 Heavy Duty Steel Truck Rack (1,700 lb. Rating)

HEAVY DUTY TRUCK RACK

 NOTICE

There may be left over components depending on up-fit. Any modification 
or unintended use of this product shall immediately void all manufacturer’s 
warranties. Manufacturer disclaims all liability for injuries to persons or 
property resulting from any modification to, or unintended use of this 
product.

 DANGER

Danger of explosion. Do not use this product for storing or transporting 
flammables, explosives, hazardous materials, or hazardous waste, such as 
containers of gasoline, solvents, gun powder, dynamite, propane tanks, 
acetylene tanks and cutting torches.

 WARNING

Always place and tightly secure ladder on rack with a sufficient barrier 
(tape/padding) between the ladder and rack. Failure to properly secure the 
ladder on the rack while in transit could cause damage leading to structural 
collapse of the ladder and potential injury or death. This product is only 
intended for, and only safe for, transporting ladders, lumber, pipe and other 
similar materials. It is the responsibility of the user to secure these materials 
to the rack before transporting. Any modifications made to this product, or 
use of this product for any other purpose than its intended use, could create 
a hazardous condition that can cause serious personal injury or property 
damage. This product is only intended and safe for use in storing and 
transporting small tools, equipment and other similar materials.
Any modifications made to, or unintended use of this product, could create a 
hazardous condition that can cause death, serious personal injury or 
property damage.

©2019 WernerCo

Part No. 24-00083 REV. C ECO 106221 8/19

Содержание 1175 02 Series










Отзывы: