Quick Start Instructions:
1.
Install 3x AAA batteries in proper orientation as shown
by opening the battery door on the underside of DVR.
2.
Insert micro SD card, connect camera
HDMI, and microphone (if recording
audio) as shown.
3.
Power on the system by quickly pressing and
releasing the push button. The green LED will
flicker for approximately 3.5 seconds while the
system boots and remain solid green as shown
when the system is ready to record.
4.
To record a video file quickly press and release push button.
Red LED will flash indicating video is being recorded.
5.
To stop recording, quickly press and release push button again. Red LED will turn off indicating
system has returned to standby mode (Green LED only).
NOTE:
If video file is currently being written to SD card, red LED may continue to blink for a moment after
push button press. This is normal and the recording will end after properly saving the file.
6.
To turn off the system, press and hold push button for 1.5 seconds. The red LED will quickly
flash and all LEDs will turn off indicating system has turned off.
Video can be played back/transferred via removing the SD card or by connecting the DVR to a
computer or other smart device via USB cable.
NOTE:
To avoid corrupting files it is always recommended to properly unmount SD cards when swapping
them among multiple devices. It is also recommended to properly eject the DVR when connected to a
computer before powering off.
Full video tutorials for all FlyWire cameras, mounts, and accessories can be found at:
www.flywirecameras.com/QuickStart
Push Button
SD Card Slot
Mic Jack
USB Connector
Camera Connector
1
2
2
3
4
4
