WDT UP 14 Z, Руководство по эксплуатации

Страница: 40 / 71

BDA UP 14 Z – 03/15 – REV. 0 Page 40 / 71
8 Normal Operation / Production Cycle
DANGER
+
Due to the risk of hand or finger injury, never try to reach into the machine before having
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard and the dies.
CAUTION
+
The pneumatic Crimp Machine UP 14 Z may only be set up and operated in perfect
technical condition, observing all the safety regulations and considering any possible
dangers.
+
The crimp machine is only allowed to be used with mounted dies and safety guard.
+
When working with the pneumatic Crimp Machine UP 14 Z, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the pneumatic Universal Crimp Machine
UP 14 Z.
+
Work with caution.
+
In cases of a machine malfunction, production must be stopped and the malfunction must
be fixed before continuing work with the machine.
+
Only one person is allowed to work on or with the machine.
+
Only trained personal are allowed to work on or with the machine.
+
Assure free access to the operating elements of the machine, especially the foot pedal.
+
It is only allowed to work with the specified working.
ATTENTION
+
Position the pneumatic Crimp Machine UP 14 Z on a flat surface and assure the stability of
the machine. Ensure that the table or bench is stable enough to support the machine in
normal use. During the utilization the machine has to be placed on a table or a similar flat
surface.
+
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
movable, so that the operator has the possibility to change his position for ergonomic and
production needs. Do not lay the foot pedal in aisles or walk ways.
+
Place the tubes on the floor so that they do not cause a trip hazard.
1. Push the tension lever back and hold it. Insert the crimp contact in the profile. Please pay
attention to the correct profile assignment and to the correct positioning within the crimp
profile!
2. Loosen slowly the tension lever that the terminal will be lightly pre-crimped.
3. Insert the wire which is stripped acc. to the specifications and position it for crimping.
4. Push the foot pedal and hold it until the complete crimping cycle is finished.
5. Push the tension lever back and hold it to remove the crimped terminal.