WDT Solfog V2, Инструкции по эксплуатации и монтажу

Страница: 30 / 43

Brine fog maker, Type Solfog V2
Index: 01 Change date: 12/12/2017 Operating instructions no.: BA DW 018-01 Solfog V2 EN.docx Page 30 of 39
Fault indications
The following fault messages may be shown. See the following fault table for removing the fault messages In case
of a failure at the device, the atomisation is interrupted.
Brine fog maker
Fault indication 1
Container empty
Fault indication 2
Filling time exceeded
Fault indication 3
Hose break
Fault indication 4
Push button cycle not active
Fault table
Fault indication / fault Possible cause Actions
Fault indication 1, Container empty;

Brine politainer empty

Hose pump not operating

Plug level control taken
off/defective

Change politainer

Check hose pump

Check plug level control
Fault indication 2, Filling time
exceeded; 
Brine politainer empty

Hose pump not operating

Plug level control taken
off/defective

Change politainer

Check hose pump

Check plug level control
Fault indication 3, Hose break; 
Pump hose defective

Check / exchange the pump hose
Fault indication 4, Push button cycle
not active 
Wrong operation mode
selected

Select correct operation mode
The device cannot be switched on 
Main fuse defective

Main switch defective

Power supply interrupted

Check / exchange the fuse

Check main switch

Check the power supply
Device without function 
Wrong setting

Main fuse defective

Control board defective

Plug pulled off

Check / reset settings

Replace fuse

Check / exchange the board

Check the plug
Solenoid valve without function 
Fuse defective

Solenoid valve / coil defective

Replace fuse

Check / exchange the solenoid valve
Hose pump without function

Fuse defective

Pump motor defective

Replace fuse

Check / exchange the pump motor
Button illumination does not work 
Fuse defective

Replace fuse
No fragrance 
Fragrance tank empty/dried

Fuse defective

Fan defective

Check / refill fragrance
Check / replace fuse

Replace dosing hose
No fog production 
No brine fog

Check the conduct on leakages

Ultrasonic brine maker defective /
exchange

Check / exchange the fan

Check the plug of the ultrasonic fog
maker
The stored adjustments will get lost 
Dip switch SW2-5 in position
ON

Set Dip switch SW2-5 to OFF