4
Batteries are located in the battery housing behind the light
the battery housing. Remove the four screws to reveal the
batteries.
When replacing the batteries, observe the correct polarity
have removed.
Use rechargeable batteries only.
Two different control switches adjust the light’s illumination time
and range of motion detection.
TIME
: Determines the duration of the light once motion is detected:
30 seconds, 60 seconds or 120 seconds.
TEST
:
SENSITIVITY:
Controls the distance of the range of motion
detection: low, medium or high.
8
5
7
6
Connect the wire from the solar panel into the socket
now begin to charge.
ON | OFF |
AUTO
ON
|
OFF
|
AUTO
ON
| OFF | AUTO
Before using the solar security light,the solar panel needs to be
connected to the light for THREE DAYS.The initial charge should
be done in the OFF(O) position.
After this, there will be enough power of batteries to operate the
light. Place the light in the AUTO(I) mode.
Push the switch to “ON”(II) to turn on the normally on mode.This
will allow a limited period of constant illumination.
Allows the positioning of the light’s motion sensor to be
tested day or night. Once the motion sensor is in the desired
position, attempt to trigger the light by moving in the
intended detection zone. If the light illuminates, the motion
sensor is positioned correctly. You are now ready to move
the switch to the preferred duration option. The light will now
only turn on in darkness.
Содержание W934D
Страница 3: ...3 5 7 8 6...
