Installing the Wavion WS-410 Metro Access Point
30 Wavion
5.
Connect the conduit to a junction box. The conduit and junction box must be IEEE/ANSI
compliant and suitable for outdoor use.
6.
Connect the AC cable to the WS-410 and tighten the nut.
7.
Connect the Wavion WS-410 to one of the following power sources:
•
AC power source (3-wire service) — 3W(P+N+PE) or 3W(2P+PE); 110-220 VAC, 50/60
Hz. See
Chapter 7: Installation Accessories
for details.
•
NEMA plug, for streetlight photoelectric control power tap (2-wire service) —2W(2P) or
2W(P+N); 100-240 VAC 50/60 Hz. See
Chapter 7: Installation Accessories
details.
8.
Reenergize the circuit and check that the power to the WS-410 turns on.
N
OTE
:
Data and power must not be enclosed in the same conduit.
N
OTE
:
If the street light is sourcing 480VAC, a special step-down power tap adaptor
must be used.
N
OTE
:
The Wavion WS-410 is equipped with additional AC surge protection and fuse
branch circuit protection. AC current protection of 20Amp should be installed.
Connect
the AC
cable
Содержание WS410
