Managing Network Interfaces
Rev 4.0
User Manual
36
Table- 3.4
Wireless page
Field
Description
•
Capacity optimization (802.11g only)
: CPE wishing
to associate to the BST must support 802.11g protocol.
•
Legacy mode (802.11b/g):
This mode allows 802.11b
CPE to associate.
•
QoS Optimization
: System is optimized for VoIP
deployments. CPE wishing to associate to the BST must
support 802.11g protocol. The CPE should support
working with multicast/broadcast data at 12Mbps.
Configure Packet priorization for QoS (per BSSID/SSID)
is a shortcut to the SSID-VLAN/BSSID list where the QoS
configuration is performed on BSSID/SSID basis.
SDMA mode
Enables or disables the use of SDMA. The feature must be
installed before usage. Please refer to
Installing the SDMA
Feature
Options
Apply
Click to have your changes take effect temporarily
Save (from the menu
bar)
Click to have your changes remain in effect after a reboot
Cancel
Click to clear your changes; this is only possible if Apply or Save
were not clicked
On this page you can configure the wireless interface. There are several recommendations for
this page.
Setting the Operational Channel
The wireless activity in a channel is an important factor in network performance. Channel
activity is indicated by the Idle Time; low values indicate high activity in the channel.
High numbers in “Other WiFi activity” means interference from a co-located channel system.
“Interferences” activity represents adjacent channel systems.
Note:
Measurements made to select a channel are best performed when
there is limited or no traffic to WBS-2400.
