Appendix G – Wave Ware Interface Specifications - 24
06 =
Invalid Status/Setup Command. Indicates that the command was
recognized as a Status or Setup command but the entire command
string was not fully interpreted by the paging system.
07 =
EEPROM Write Error. Indicates an internal system error in the paging
system with regard to the proper storage of configuration information.
This condition would likely indicate that paging system repair is
required.
08 =
Invalid Command Format. Indicates that the command was not fully
recognized as a valid paging system command.
Example 1:
<SOH>A,5,46180,<STX>This is a test<ETX><EOT><SOH><ACK>V3.00,00,0,1,1A<EOT>
echoes the paging message command and acknowledges proper receipt of a command by appending the
ACK, indicating paging system firmware version is 3.00, no paging messages in queue, no carrier
signal is being detected, and Carrier Detect mode is set to ON. The last field does not currently provide
useful information.
Example 2:
<SOH>4,5,0000006<EOT><SOH><NAK>03<EOT><CR><LF>
echoes the paging message command and indicates an error in receiving a command due to an invalid
paging receiver capcode in a Paging Message command. Includes a <CR> and <LF> at the end of the
response string if they were included in the paging message command.
SETUP COMMAND
You may program the
WaveWare Paging System
to monitor for interference using the Carrier Detect mode. If
the Carrier Detect mode is turned on, the paging system will hold paging messages in queue until an offending
carrier signal is no longer detected at the transmission frequency of the paging system. The settings programmed
by the Setup command will be remembered by the paging system even if power is removed from the paging
system. The Setup command is formatted as follows:
<SOH>S,X,V<EOT>
Where the S indicates Setup Mode, X is the command type, and V is the value. The comma delimiters are
optional.
X
A single numeric value used to indicate the command type. The numeric character is followed
by a comma.
Valid values (X) are:
1 =
Carrier Detect Mode
V
A single numeric value used to indicate the value of the command setting to be saved. The
numeric character is followed by an EOT character.
Valid values (V) are:
0 =
Off
