Lights do not turn OFF
1. There can be up to a 30 minute time delay after the last motion is
detected. To verify proper operation, set DIP switch 1 to
ON
, then reset
switches 1, 2, and 3 to
OFF
to start Test Mode. Move out of view of the
sensor. The lights should turn
OFF
in approximately 5 seconds.
2. Verify that the sensor is mounted at least six feet (2 meters) away from
any heating/ventilating/air conditioning device that may cause false
detection. Verify that there is no significant heat source (e.g., high
wattage light bulb) mounted near the sensor.
3. If the lights still do not turn
OFF
, call 800.879.8585 for technical support.
Sensing motion outside desired areas
1. Select PIR Sensitivity – Low (DIP switch 5 =
ON
) if necessary.
2. Mask the PIR sensor’s lens to eliminate unwanted coverage area.
Red LED is OFF all the time and the sensor features don’t work.
1. Check DIP switches 1,2,3. If they are all
ON
the unit is in Service Mode.
Set the DIP switches to a valid Time Delay setting.
2. If re-setting the Time Delay switches does not set the sensor features
call technical support.
COVER PLATES
WattStopper PW series wall switches fit behind industry standard
decorator-style switch cover plates. Cover plates are not included.
Units come in the following colors, which are indicated by the final suffix
of the catalog number (shown here in parentheses):
White (-W), Light Almond (-LA), Ivory (-I), Grey (-G), Black (-B).
