wattstopper EW-200-120, Руководство по установке

Страница: 7 / 12

WIRING AND INSTALLATION (CONTINUED)
Orange(Common)
Isolated Relay
Green (Normally Closed)
Yellow (Normally Open)
EN multiple sensor/load wiring
Neutral
Red (Load)
Black Black
White White
White
White
White
Black
Red (Load) Black
Black
Switch
(optional)
Line
Load Load
Sensor
Sensor
Wire the sensor as shown below:
• BLACK wire from sensor to line voltage.
• WHITE wire from sensor to Neutral.
• RED wire is connected to lighting loads, if used, as shown (see diagram above and
below), not to exceed load rating (see Specifications, front cover).
• Isolated Relay (EW-200 models only. See Specifications, front cover, for rating).
Connect the wires necessary to the application that requires this output.
▸
ORANGE (Common) (must be used for proper operation).
▸
GREEN (Normally Closed) (Open when occupancy is detected).
▸
YELLOW (Normally Open) (Closed when occupancy is detected).
Call 1(800) 879-8585 or 1(972) 578-1699 For Technical Support 6
Note: Note: When power is restored to the sensor, the lights will turn on. If no motion is
detected by the sensor, the lights will remain on for approximately one minute and then turn off.
(See Security Override, page 9.)
Multiple sensors (optional)
connected in parallel
Multiple loads (optional)
connected in parallel