WIRING AND INSTALLATION
CAUTION
TURN POWER OFF AT THE CIRCUIT BREAKER BEFORE INSTALLING SENSOR .
SENSOR MUST BE INSTALLED BY QUALIFIED PERSONNEL ONLY .
4" round
outdoor
junction-box
Cover plate
To Controlled
Loads
Check Our Web Site For FAQs: www .wattstopper .com
5
RED
BLACK
WHITE
Gasket
IMPORTANT! thread wires through gasket
before connecting
4" round
outdoor
junction-box
Cover
plate
To additional Controlled
Loads
(optional)
RED
BLACK
WHITE
Wire connections when attaching lamp holders (Isolated relay wires not shown)
WARNING: WHEN USED WITH LAMP HOLDERS THE LAMPS NEED TO BE 1/2” OR
GREATER FROM THE SENSOR .
Wire connections for sensor (also see instructions, page 6)
Attach cover plate assembly and
gasket to the junction box with 4
screws and screw covers (supplied)
IMPORTANT! Make sure that the
gasket seats properly when attaching
the cover plate
Attach cover plate assembly and gasket to the
junction box with 4 screws and screw covers
(supplied)
IMPORTANT! Make sure that the gasket seats
properly when attaching the cover plate
Lamp holder
(CANLET lamp holder shown)
Gasket
IMPORTANT! thread wires through
gasket before connecting
Isolated Relay Wires (N/O, COMMON, N/C)
(EW-200 models only)
NOTE: Weather proof caulking may be required
around junction box and cover plate to provide a
weatherproof seal in some installations.
NOTE: Weather proof caulking may be required
around junction box and cover plate to provide a
weatherproof seal in some installations.
