Watts WQT4 RO Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 19

Page 9
Step 17
Step 18
Make sure the O-Ring is located at the bottom of recess for the tank
connection.
Tank Valve Installation - (Metal Tanks)
Do not let the tape cover the opening
in the fi tting.
*Note:
Drain Saddle fi ts standard 1 ¼” – 1 ½” drain pipes
Drain Saddle Installation
Step 14
Step 15
Step 16 Drill a ¼” hole through the drain pipe at least 1 1/2” above the nut
of the P-trap to allow for the removal of the P-trap if necessary.
Assemble the drain saddle around the drain pipe. Position the
drain saddle over the drilled hole in pipe. Insert screw driver into
the opening of the drain saddle and align with drilled hole in drain
pipe. Using Phillips screw driver tighten screws evenly and securely
on both sides of the drain saddle. The black tubing will be installed
later.
The small square black foam gasket with a circle cut out of the middle
must be applied to the inside of the drain saddle. Remove sticky tape
backing and stick to the drain saddle as shown.
2 Screws 1 Semi bracket with opening
2 Nuts for screws 1 Foam washer
1 Semicircle bracket
Gather the pieces of the drain saddle
Caution: Do not over tighten the screws. It may crack the drain saddle.
If you have a garbage disposal, do not install the drain line near it. Installation
of the drain line must be either above the disposal, or if a second sink drain is
available, install it above the cross bar on the second sink. Installation of the
drain line near a garbage disposal may cause the drain line to plug. Caution:
Tank Valve Installation - (Plastics Tanks)
Step 17
Wrap 3 to 4 turns of Tefl on tape clockwise around the male pipe threads
coming out of the top of the tank.
Step 18 Thread the plastic valve onto the tank fi tting . Do not over tighten or
the valve could crack.
Thread the plastic valve onto the tank fi tting. Do not over tighten or
the valve could crack.