11
By pressing
for 5 seconds, the
controller goes in RF pairing menu.
Bu using and
select zone 3
(Red led), press
to enter in
Pairing with a slave device mode.
All LEDs are blinking red.
Put the device in RF pairing mode
When link is done WFHC 02 HC RF
and BT-WR02 RF return to normal
mode.
This configuration allows a remote
pump output.
REMARK:
Instead of BT-WR02-RF,
you can also use BT-FR02-RF
By pressing
for 5 seconds, the
controller goes in RF pairing menu.
Bu using and
select zone 3
(Red led), press
to enter in
Pairing with a slave device mode.
All LEDs are blinking red.
Put the RF repeater in RF Link mode
(press 3 s on the button)
When RF link is done, WFHC 02 HC
RF returns to normal mode and the
led on the repeater becomes green
fix.
5.1.2 Multiple controller’s installation
If there are multiple interconnected controllers in the installation, there are 1 main-controller and up to 3 sub-controllers.
The main controllers centralizes the information for the sub-controllers. If a WFHC HCM 02 RF 230 is used, it should be
paired to the main-controller.
•
The main-controller propagates the Heat and Cool mode to the sub-controllers. This information could come from
the WFHC HCM 02 RF 230 or from a Master Digital thermostat according to the DIP4 and DIP5 (See 4.3)
•
The main-controller could handle the pump signal of the whole installation according to DIP1 (See 4.3)
Main WFHC 02 HC RF
WFHC HCM 02 RF 230 (Option)
BT-WR02 RF (Option)
BT-D03 RF
BT-A03 RF
Sub WFHC 02 HC RF
Sub WFHC 02 HC RF
Sub WFHC 02 HC RF
Содержание WFHC 06Z 02 HC RF 24
Страница 2: ...2 USER GUIDE GB...
