Aegis Sequencer
Remote Interface
L-OMM-015_0B
• 8/8/2023 Technical Support • (800) 433-5654 • Mon-Fri, 8 am - 5 pm EST
25
of
38
6.2. Alarms Log
The Alarms Log menu allows access to the following alarms log display screen.
The alarms log memorizes the unit operation status when the alarms are triggered. Each log entry is an
event that can be displayed from among all the events available in the memory.
The information saved in the alarms screen will also be saved in the alarms log. The maximum number
of events that can be saved is 64. Once the limit is reached, the most recent alarm will overwrite the
oldest one.
The alarms log can be cleared in the Settings menu (mask Ef1) through the specific command, or by
pressing and holding the alarm key for 3 seconds.
7. Remote Interface
The ethernet connection for the remote interface of the Sequencer connects into the second port of the
ethernet switch inside of the Sequencer. The other end of the ethernet cable will then connect to a
computer.
To see the remote interface of the Sequencer, the IP address of the Sequencer must be entered in an
internet browser followed by
“/commissioning/index.html”.
Example: 192.168.1.152/commissioning/index.html
From this remote interface the Sequencer can be controlled in the pGD1 tab. Information about the
Sequencer and the system can also be accesses through this remote interface in the other tabs on the
left side of the screen.
By searching the IP address of each unit in a new tab on an internet browser, the unique remote
interface of each unit can be accessed via the same ethernet connection. This interface gives access to
change the user and service setting of the individual Aegis units as well as the diagram showing the
components of the heat pump operating.
