Watts Premier Sof-Tek, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 36

Figure# Part# Item Qty. Description
1 93810 Injector Screen 1 Acts as a pre-fi lter to keep debris from entering the Injector Nozzle
and Injector Throat. Attaches to the cylinder on the Nozzle plate and
spherical “bump” inside the Main Valve Body. Some compression of
the Screen may occur during assembly. The openings in the screen
must be clear to ensure proper fl ow to the Injector assembly.
2 93223 Injector Throat 1 Creates the vacuum that draws the brine solution from the brine
cabinet in conjunction with the Injector Nozzle (Part # 93221.) The
center hole should be clear of debris, round and undamaged. The
Injector Throat should be pressed fl ush into the opening in the valve.
If the Throat needs to be removed, it should be replaced with a new
one.
3 93220 Bottom (Thick)
Injector Seal 1 Seals between the Injector Nozzle and the Main Valve Body. The
gasket has a defi nite hole pattern that has to match-up with the
Nozzle and Main Valve Body opening. The gasket seals at its outer
edges and between the inlet screen and nozzle opening. These
areas must be free of defects such as tears or pits and be free of
debris.
4 93221 Injector Nozzle 1 Creates the vacuum that draws the brine solution from the Brine
Cabinet in conjunction with the Throat (part #93223). There are two
openings in the Injector Nozzle plate. The small hole, fl ush on both
sides, is the one that creates the “injection-stream” that enters the
Injector Throat. It is very important that this hole be clear of debris,
round and undamaged. If this hole becomes “clogged,” do not use
anything to clear this opening that could damage it, such as metal
objects. Use a clean cloth and fl ush with water. If necessary, a
wooden toothpick may be used. When assembling to the Main Valve
Body, the Injector Nozzle hole should line up with the Injector Throat.
5 93232 Top (Thin)
Injector Seal
1 Seals between the Injector Nozzle and the Injector Cap. The gasket
must be free of defects such as tears or cuts and be free of debris.
6 93222 Injector Cap 1 Holds the Injector assembly together and seals the assembly to the
Main Valve Body.
7 90807 Injector Screw 4 These four machine screws should be tightened evenly and snugly.
Parts Diagrams
Injector Assembly
Figure 13
23