![background image](http://html1.mh-extra.com/html/wattbike/cycle-trainer/cycle-trainer_assembly-and-service-manual_3733796003.webp)
3
2. Assembly and Set Up
Instructions for Assembly
Tools required: 6mm Hex Allen Key and Multi Spanner (17mm, 15mm & 14mm).
The Wattbike must be assembled with due care by at least two adults. If in doubt call upon the help of a technically qualified
person.
The Wattbike is 654mm wide, 1230mm long and has a maximum height of 1300mm.
When taking the Wattbike out of the packing box do not lift or carry the Wattbike bike using the plastic covers – take a firm hold
of the frame and steel handlebar and saddle stems - two adults are needed to lift the Wattbike.
The Wattbike is heavy – 55kg. Make sure you hold it securely whilst fitting the rear and front feet, when lowering it to the ground
and when moving it around.
2.1 Unpacking Small Parts
Leaving the main body of the Wattbike in the box, unpack and lay out all the items from the packaging and ensure that you have
all the items below:
1. Rear foot (no wheels attached)
2. Front foot (wheels attached)
3. Right & Left pedals - These are a combination pedal SPD and toe clip options.
4. Recreational Wattbike saddle (Race saddles are available as optional extra)
5. Handlebars with Wattbike Performance Computer bracket attached
6. Wattbike Performance Computer
7. 4 x 6cm bolts, washers and nuts for the rear and front leg
8. Saddle bottom plate (smaller plate), adjustment lever and washer
9. Saddle slider
10. Handlebar bottom plate (larger plate), adjustment lever and washer
11. 2 x 25 mm thumb screws for fixing the Wattbike Performance Computer to the handlebar bracket
12. Plug-in battery charger
13. 3m USB cable
2.2 Unpacking Main Body of the Wattbike
With a suitable assistant, lift the Wattbike out of the box holding the Wattbike as shown in the image,
and lower gently onto the ground. Do not let go of the Wattbike as without the front and back foot
the Wattbike is not yet fully stable.
2.3 Attach the Rear Foot
Ask your assistant to lift the rear of the Wattbike up and align the 2 holes in the rear foot with the 2
holes in the frame of the bike. Please do support the weight of the Wattbike on the fan cage at the
front of the bike. Push the bolt up through the hole in the foot and frame place the washer over the
thread of the bolt and then thread the nut onto the bolt and tighten using the 6mm Hex Allen Key for
the bolt and 17mm spanner for the nut.
Gently lower the Wattbike to the floor.
1.
3.
5.
9.
4.
6.
8.
7.
10.
11.
12.
13.
2.
Manuals and software for the Wattbike can
be downloaded at
wattbike.com/software
Содержание cycle trainer
Страница 1: ...ASSEMBLY SERVICE MANUAL ...