22
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to [email protected]
❑
Carefully mount the top wing to the center cabane strut
using two M3 x 8 machine screws.
IMPORTANT
Make sure to use the two M3 x 8 machine
screws and not two M3 x 6 machine screws.
☞
Airplane pictured upside down for photo clarity.
❑
Mount the two outer wing struts to the mounting brackets
using four M3 x 6 machine screws.
IMPORTANT
There are separate right and left struts and
they will fit properly in only one direction. When positioned
properly, the predrilled holes in the struts will line up with the
predrilled holes in the mounting brackets and the ends of the
struts will be flush with the surface of the wings.
❑
Kwik Bond Thick C/A
❑
# 1 Phillips Head Screwdriver
❑
7/64" Hex Wrench
❑
Wire Cutters
❑
Excel Modeling Knife
❑
Scissors
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
❑
(1) Spinner Assembly w/Mounting Screws
❑
(1) 7 x 4 Propeller
SECTION 12: FINAL ASSEMBLY
❑
(1) Velcro
®
Strip
❑
(1) Decal Set
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
Electric or Hand Drill
❑
1/4" Drill Bit
❑
Ernst Airplane Stand
❑
K&S 30 Watt Soldering Iron
❑
Solder
Step 1: Installing the Propeller & Spinner
❑
Test-fit the nylon propeller adapter rings over the propeller hub and remove the one that's the closest fit.
❑
Press the nylon propeller adapter ring into the spinner backplate.
❑
Using a 1/4" diameter drill bit, very carefully enlarge the hole in the propeller.
IMPORTANT
We strongly suggest holding the propeller with a heavy rag while enlarging the hole. The propeller
blades are very sharp and they could cut your hand if the drill bit bites and spins the propeller around.
