9
Continued On Next Page
☛
☛
☛
☛
☛
STEP 4: ROUTING THE ANTENNA
❑
Uncoil the receiver antenna and secure it under the two
plastic fasteners located on the carbon-fiber center brace.
❑
Pull the antenna taut, then feed the end of it up through
one of the small predrilled holes in the plastic mount at the
very front of the kite wing assembly. Allow the excess
antenna to hang out the front of the kite wing assembly.
✦
✦
✦
✦
✦
WARNING
✦
✦
✦
✦
✦
Under no circumstances should you cut
the receiver antenna shorter. Allow the excess to hang
out the front of the kite wing assembly. Cutting the
receiver antenna can greatly shorten the range of the radio
control system.
STEP 5: INSTALLING THE FLIGHT BATTERY
✦
✦
✦
✦
✦
WARNING
✦
✦
✦
✦
✦
Do not charge the flight battery before installing it. Charging will be done later.
❑
Remove the plastic battery door from the bottom of the
fuselage pod by carefully pulling forward, then up, on the
latch at the back of the battery door.
✦
✦
✦
✦
✦
WARNING
✦
✦
✦
✦
✦
Before plugging in the flight battery, verify
that the On/Off switch on the bottom of the fuselage pod
is in the "off" position.
❑
Plug the connector on the flight battery into the
connector that is inside the fuselage pod. When plugged
in properly the connectors should "click" together.
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
As a safety feature, the connectors can
only be plugged in one way.
