Watlow RMA PLUS RMAP-2A Series, Руководство пользователя

Страница: 38 / 75

Version 1.0 PN: 2042-8198
Page 38 of 75 DN: 10-32813
Multicast Storm Protection
Multicast storm protection is enabled for the same reason as broadcast storm protection. IP phones
and some industrial networks such as EtherNet/IP generate significant multicast traffic.
Port Mirroring
Port mirroring is an advanced switch feature disabled by default. To use this feature, you must add the
key
SnifferPort to the setup file. The configured port will mirror all packets received and transmitted on
port 3 (internal switch connection to RMA PLUS). Connect a PC running Wireshark on the sniffer port to
capture all traffic seen by the RMA PLUS. This is an invaluable network diagnostic tool.
MAC
Filter
Setup keys: MACA(1-3)
The RMA PLUS implements unicast Source Address (SA) filtering. If configured, the RMA PLUS will filter
out all MACs except those configured in the acceptance filters
MACA(1-3) . Use MAC filtering to add a
layer of anonymity to your network.
Addressing
The RMA PLUS currently implements IPV4 static and DHCP addressing. Static addressing is the preferred
method.
If DHCP is selected and the device does not get an address from the server, the RMA PLUS will fail to the
static IP address after a timeout period.
NetBIOS Name Service
The RMA PLUS implements NetBIOS-NS. This means the RMA PLUS may be addressed by its IP address
or NetBIOS / host name. The format of the NetBIOS name is RMA-<Serial Number>. Ensure that
NetBIOS is enabled in the network adapter settings for this feature to work.
Example: RMA-1894854 (where 1894854 is the device serial number)
Watbus Over Ethernet (WOE)
Setup keys: Discover
The RMA PLUS provides up to three (priority based) Ethernet to high-speed Watbus gateway sessions.
Each connection provides access to the RMA PLUS and all devices connected to the high-speed Watbus
network. Transactions intended for remote devices are proxied (routed) through the RMA PLUS to the
Watbus network.
The keep-alive feature is enabled on all accepted sockets. This prevents socket leaks if a socket is not
closed properly. Typical causes include application hang / crash, loss of link, severed network, half close,
etc.
This service is enabled by default for all model numbers. It may be disabled by writing “No” the Watbus
Enable member. NOTE: A reset is required for this change to take effect.
Ethernet 70 (0x46), Instance 2
Member ID Member Name Data Type Access NV Min Max Default Comments / Description
7 0x07 Watbus Enable ENUM16 RW F 106 59: No
106: Yes