Watkins Solana, Руководство пользователя

Страница: 32 / 63

4. When empty, inspect the spa shell and clean as required. (Follow the Care of the Exterior Finish instructions.)
5. Remove the filter cartridge and clean as required (see the Filter Maintenance section).
6. Replace the filter cartridge.
7. Close the drain valve and reinstall the drain cap.
8. Refill the spa through the filter compartment BEFORE restoring power.
IMPORTANT: Always clean the filter cartridge each time the spa is drained for cleaning. Always sanitize and chemically balance
the spa water after cleaning and refilling the spa.
FILTER MAINTENANCE
As with any water filtering system, the filter cartridge may become clogged, resulting in reduced water flow. In your Solana
™
spa, it is
important to maintain a clean, unobstructed filtering system to ensure maximum performance from the jets. Watkins Manufacturing
Corporation recommends the filter cartridge be cleaned with a filter cleaner at least once every month.
WARNING: The frequency and duration of use, and the number of occupants all contribute to determining the appropriate time
between filter cleanings. More use means that more frequent filter cleanings are required. Failure to maintain the filter cartridge in a
clean, unobstructed condition will result in reduced water flow through the heater assembly that may cause the High Limit Thermostat
or Pressure Switch to trip. If this high limit or pressure switch trip occurs during sub-freezing temperatures and goes unnoticed, the spa
water may freeze. Any damage to the spa (due to freezing) caused as a result of poor maintenance (stated under misuse or abuse in the
Solana
™
Spa Limited Warranty), will not be covered by your spa warranty.
DANGER: To reduce the risk of injury to persons using the spa, DO NOT use the spa with the filter cartridge or filter standpipe
removed!
F
ILTER
C
ARTRIDGE
R
EMOVAL AND
C
LEANING
1. Disconnect power to the spa.
2. Remove and carefully set aside the filter compartment cover.
3. Remove any floating items from within the filter compartment.
4. Turn the filter retainer handle (located on the top of the filter cartridge) counterclockwise until the retainer can be removed from the
filter standpipe.
30
™