Watkins Wellness HotSpring Hot Spot Relay, Руководство пользователя

Страница: 19 / 36

Page 16 Spa Control Panel
WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.
Do not attempt service of the control box. Contact Customer Service at 800-999-4688 (Extension 8432) for assistance. Follow all owner manual power
connection instructions. Installation must be performed by a licensed electrician and all grounding connections must be properly installed.
DIAGNOSTIC LCD MESSAGE
Message Meaning Action Required
No message on display.
Power has been cut off to the spa. The control panel will be disabled until power returns. Spa settings will
be preserved until next power up.
HL The system has shut the heater off because the
temperature at the heater has reached 122°F (50°C).
Do not enter the water!
DO NOT ENTER THE WATER. Remove the spa cover and allow the
water to cool down, then shut power off and power your spa up again
to reset the system. If spa does not reset, shut off the power to the spa
and call your Hot Spring Dealer.
AOH Temperature inside the equipment compartment is too
high 194°F (90°C), causing the internal temperature in
the control system to increase above normal limits.
Open equipment compartment and wait until error clears.
PRR A problem is detected with the temperature probe. Call your Hot Spring Dealer.
OH The water temperature in the spa has reached 108°F
(42°C). Do not enter the water!
Remove the spa cover and allow the water to cool down to a lower
temperature. Call your Hot Spring Dealer if problem persists.
UPL No low level configuration software has been installed
into the system.
Call your Hot Spring Dealer.
FLO No water flow is detected by the control system but flow
is expected.
Make sure that the jet pump is running and water is flowing; check and
clean filters; make sure water valves are open; make sure spa has a
proper water level. If problem persists, call your Hot Spring Dealer.
SETTING ECONOMY MODE
In Economy mode you are able to lower the set temperature of the spa
by 20º F (11º C) during a certain period of day which is adjustable as
well as the length of time. One of the main reasons you might want to
enable this feature at night is to limit the amount of times the spa will
automatically turn on either because of calling for heat or sampling the
water for temperature.
NOTE: If the Economy Mode set time is enabled during a filter cycle, the
filter cycle will NOT come on during the enabled time.
To enable the economy mode:
1. Press and hold Light button for 5 seconds until clock hour is
displayed, press Light button several more times until EPx is
displayed, x representing the state of the mode (0=disabled,
1=enabled)
2. Press the Up +/Down - button to either enable or disable the
economy mode.
3. Press the Light button again to set the Economy Start time. The
display will show ESxx where "xx" represents the hour at which
the economy mode will become active. Press the Up +/Down -
button to set the hour you want the mode to be enabled.
A dot after the ES represents AM.
NOTE: The time may be set, however, if Economy is disable - 0,
the Economy Mode feature will Not come on.
4. Press the Light button again to set the Economy Duration time.
The display will show Edxx, "xx" representing how long (in hours)
you want the economy mode to be ON. Use the Up/Down buttons
to adjust the amount of hours.
FAHRENHEIT/CELSIUS SETTING
To change water temperature display to either Fahrenheit or Celsius,
press and hold Light button for 5 seconds until clock hour is displayed,
press Light button several more times until F or C is displayed. Press the
Up/Down button to change. Wait 15 seconds to allow the exit timer to
expire and store the setting.
English French Spanish