Operational maintenance and replacement requirements are
essential for this product to perform as advertised.
USING
THE
COUNTERTOP
DISTILLER
1. Set Distiller on a dry, level, well-supported, stable surface.
2. Unplug fan cord from fan cord receptacle. Remove cover and set
aside (fi g. D).
3. Fill stainless steel tank to “FULL” line with approximately 1 gallon
(3.8 liters) ordinary tap water. DO NOT OVERFILL (fi g. E).
4. Check to be sure fi lter cup is locked in place.
5. Replace cover on boiler tank and plug fan cord into receptacle.
6. Center collection/storage bottle opening under fi lter cup with
adapter cap in place (fi g. B).
7. Plug power cord into a properly rated, grounded outlet.
8. If red indicator light is not lit, press reset button to turn on
Distiller. Red indicator will light and fan motor will start.
9. After about 30 minutes, distilled water will begin to fi ll collection/
storage bottle. When cycle is complete (approximately four hours for
1 gallon), Distiller turns off automatically. Wait at least 30 minutes
before
removing
cover!
NEVER remove cover while fan is running.
Severe burns can result from boiling water or steam.
WARNING: DO NOT CHANGE POSITION OR LOCATION OF
DISTILLER WHILE IT IS OPERATING OR COOLING. WAIT AT
LEAST TWO HOURS AFTER CYCLE IS INTERRUPTED BEFORE
MOVING DISTILLER. SEVERE BURNS CAN RESULT FROM
BOILING WATER OR STEAM.
Cover
Figure D
Boiler Tank
Power Cord
Fan Cord
Fan Cord Receptacle
Waterwise Model 4000 Distiller Use & Care Guide
7