INSTALLATION INSTRUCTIONS
6. Securely snap all (8) eight oval slot plugs (#3) provided onto the (8)
eight slots in the drain cover support plate (#8).
This replacement SOFA is only acceptable for use if the
provided fasteners can be installed as intended by these instructions
Verify proper installation by checking that the sump dimensions
meet the required dimensions shown for values A through F as
well as the required pipe size.
7. Attach the drain cover (#2) to the drain cover support plate (#8)
using the tool and the three 10 x 7/8 security screws provided. Waterway
requires the use of security screws to secure the cover. Apply 20 In-Lbs
torque to three Torx Security Screws on the cover. Ensure proper fit and
no play.
CAUTION: Use only supplied screws to secure the cover. DO NOT
use power tools.
NOTE:
For fastener repair, evaluation and replacement - if any of the listed fastener or fastener receptacles in these instructions are damaged in any
manner such that that the required torque specification cannot be achieved, both the fastener and receptacle parts must be replaced
4. Align the drain cover support plate and ring over the ring or sump. The
top of the outlet pipe should be recessed a minimum of 1 inch from the
back of the plate (Figure 4).
5. Attach the drain cover support plate (#8) to the pool or spa surface
with the appropriate screws as described in 3 above. Once installed, be
sure that the drain cover support plate is firmly in place and cannot be
pulled out of the pool or spa surface. The Drain cover support must be
firmly in place or
DO NOT
proceed to next step.
Figure 4
810-0257-2017.0521
©2021 Waterway Plastics
