Ultra Retro is an underwater suction drain cover system intended to replace any drain cover up to 10 inches in diameter.
The maximum flow rate for Ultra Retro is 178 gallons per minute (GPM) Floor and 132 GPM Wall. Ultra Retro should operate best when used with
residential pumps of up to 3 HP. Please ensure your pool or spa pump system meets this specification.
CAUTION:
if you do not have two underwater points of suction in your pool or spa for each pump, safety issues regarding suction
entrapment exist and could cause serious injury or death. Although Ultra Retro incorporates patent pending features to
better protect from suction entrapment, this product may not resolve all single point of suction issues. If you do not have two
underwater points of suction for each pump in your pool or spa, we recommend you contact a licensed pool builder or remodeler
to install a second point of suction.
VINYL ULTRA RETRO SUCTION OUTLET - IMPORTANT INFORMATION
ULTRA RETRO SUCTION OUTLET INCLUDED COMPONENTS
Your Ultra Retro includes five important components. All components #1-4 below must be used for proper installation. These components are as
follows:
1. Gray drain cover support plate
2. Drain cover
3. Vinyl ring
4. Eight white plastic oval slot plugs that must be installed in the drain cover support plate after it is affixed to the pool or spa surface
5. Three #10 x 7/8" security screws to secure drain cover to drain cover support plate, together with a tool for installing these screws
6. Assorted screws and fasteners for attaching drain cover support plate to pool or spa surface (see Figure 1)
See the following Installation Instructions to determine which components you will need to use for your installation.
2
2
2
2
3
QTY.
1
2
Figure 1
810-0257-2017.0521
©2021 Waterway Plastics
