A
C
D
E
F
B
CONNECT THE PULLDOWN SPRAY HOSE
CONNECT THE PULLDOWN SPRAY HOSE
Before connecting supply hoses,
flush supply stops to clear any
debris. Place a bucket underneath
stops and run water for 5 to 10
seconds. Turn water off. Carefully
position hot and cold supplies so
they will not interfere with other
hoses. Connect supply hoses (A)
to supply stops (B).
DO NOT
use
teflon tape or plumbers putty.
Turn water back on and check for
leaks.
CONNECTING SUPPLY HOSES
CONNECTING SUPPLY HOSES
A
B
HOW TO ADJUST HANDLE POSITION AND HANDLE TENSION
HOW TO ADJUST HANDLE POSITION AND HANDLE TENSION
On some kitchen countertops, the handle may hit the
backsplash when the faucet handle is positioned to the left
or right (Fig. 1). Waterstone gives you the option of adjusting
the handle 45 degrees to avoid hitting backsplash.
FIG.1
OPTIONAL DECORATIVE BUTTONS
OPTIONAL DECORATIVE BUTTONS
Place a small standard screwdriver in slot at bottom of
metal ring that surrounds handle button (A). Gently
pry button from handle (B). Unscrew and remove
holding screw (C) and washer (D). Hold handle in a
vertical position. Wiggle and pull straight off faucet.
Rotate handle away from backsplash
45 degrees then slide handle back
onto valve stem (E). Insert holding
screw with washer and tighten. Snap
handle cap back into place. To adjust
handle tension, turn ring (F) clockwise
to increase or counterclockwise to
decrease handle tension.
HANDLE ON LEFT
HANDLE IN FRONT
HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H
C
A
B
C D
A
B
E
E
G
C D
F
F
A
C
B
Connect spray hose (A) to spray
connection hose tube (B).
NOTE –
make sure spray hose
(A) and counter balance (C) are
free to slide up and down and
are not in conflict with any
plumbing components or
items under sink.
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
To change button, find the slot (A) at bottom of retainer
ring (B). With a small standard screwdriver, gently
pry retainer ring from faucet handle (C). Remove
button assembly (D). Insert new button by
lining up pin (E) on handle with hole (F)
on bottom of button assembly. With
slot facing down, press the button
retainer ring firmly back into
place.
