WATERS NETWORK SYSTEMS
™ ProSwitch
®
-
2600M User’s Manual
Page
30
3. Then
select
Yes or No
to confirm the file transfer via Kermit.
4. Start
the
file transfer
(receive) operation in the terminal program with Kermit protocol.
Other Menu Functions
The remaining menu options provide the following functions:
Logout
– Use to logout of switch.
Save Settings
– All settings in the configuration process will take effect immediately. But, they will be lost
once the power is turned off. To save them, use this function to save the settings to the flash chip.
Restore Default Settings
– Use this function to return to the factory default settings. This option clears
current settings. After restoring the default settings, the switch will reboot.
Reboot
– Use this function to reboot the switch.
8.0
Use Web Browser to Configure 2600M
The 2600M provides a web-browser interface for configuration/ management purposes. Once the IP address of
the switch has been assigned through the console interface, you can connect to the switch with your web-
browser for configuration or management. Refer to the section:
Using DHCP to Set the IP Address of the
Switch
. You must have your password to log into the switch from the Web. Web access provides the same
features as connection through the console or Telnet, however, the menu options are slightly different.
Logging into the 2600M
Follow these steps to use the load the management software from your web browser.
1. Load
your
web browser
. (MS IE 4.0 / Netscape 4.7 or above w/ 800x600 screen resolution is suggested,)
2. Enter "http://xxx.xxx.xxx.xxx/" as the web address. (xxx.xxx.xxx.xxx is the IP address that you have set for
the 2600M. There is no default IP for the 2600M.) The login screen will be displayed.
3. Input the password. The default password is
123456
for
admin
.
Note
: You may change the password once your log into the switch.
4. The homepage of the 2600M will be displayed.
