Battery
cable
Step 6
Take the SmartRow assembly and slide it in place as indicated
in the picture. Make sure the smaller plastic part encloses the
wooden top deck (as seen in the circle). Mount the upper two
Tie-Rods. If SmartRow is correctly in place, tighten all bolts
must be on the left side.
Step 7
Hold the handle in the correct position (screws down) and feed
the drive strap over the SmartRow. Pass the drive strap around
the SmartRow and underneath the top-deck back towards the
clutch housing.
Step 8
Step 9
Carefully pull the recoil belt, causing the drive strap to wind
itself around the clutch. When the handle arrives near the
SmartRow pulley it is important that the recoil belt wraps 1 or
2 turns around the recoil bush before you go to the next step.
Once this is done, feed the recoil belt over the two pulleys in
the forward riser.
DRIVE STRAP
RECOIL BELT
Step 10
Stand the WaterRower upright and reconnect the bungee to
the recoil belt. Use the double-sided foam tape to stick the
battery pack to the metal bracket. Feed the battery-cable of the
SmartRow downwards and connect the clip to the battery pack.
Lay the WaterRower down and pull the handle once. You
should see blue light coming out of the SmartRow indicating
that it is trying to
establish a Bluetooth
connection. Open
the ‘SmartRow’-app
(go to settings >
SmartRow) to make
a connection.
SmartRow
WRM_7555
