Waterous VPO Priming System, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 56

45
|
56
Safety Introduction Product Overview Installation Operation Maintenance
Connecting the Priming Components
1
2
4
3
Priming Pump and Priming Valve
Use the illustration and instructions to make the
connections on a single priming pump and single
priming valve application.
1 Install the outlet muffler if it is suitable to your
application. Alternatively, locally source the
components required in your application to
direct the priming-pump exhaust away from
people to avoid injury and equipment to avoid
damage.
Note: Make sure to use a minimal bend radius
and arrange the hose to allow proper
draining.
2 Install a 3/4-inch NPT fitting with a 3/4-inch
hose connection to the priming pump inlet.
3 Install a 3/4-inch NPT fitting with a 3/4-inch
hose connection to the priming valve outlet.
4 Use an appropriate hose to connect to the
fittings on the priming pump and priming valve.
Refer to: "Hose and Tubing Requirements"
on page 25 to select the appropriate hose.
Make sure that you install the hose so that it
drains from the priming valve to the priming
pump.