T-365
Page 39 of 75
Reassembly - Assembly Cap
Hydraulic Pump on Front of PTO
Bearing
Driven Shaft
Cap
Bearing
Wave Spring
Four (4) 3/8-16 x 1 in.
Screws and Lockwashers.
Torque to 31 lb-ft
Front Cap Flange
Front
Rear
Rear Cap Flange
Four (4) 3/8-16 x 1 in.
Screws and Lockwashers.
Torque to 31 lb-ft
1.
Use high pressure grease to coat the driven shaft's sprocket and bearing
journals.
2.
Press the bearing to the shoulder on the internal spline end of driven shaft.
3.
Tap the key into place.
4.
Place high pressure grease in the rear bore of the cap.
5.
Tap the bearing into place.
6.
Set the bearing cover in cap and secure with the hex head screws. Hand
tighten only at this stage of reassembly.
7.
With the cap resting on the rear face, position the spacer and driven sprocket
inside the cap.
8.
Take the driven shaft, bearing and key assembled previously and from the
front side of the cap, slide the shaft through the bore in the cap into the bore
of the driven sprocket, spacer and ball bearing lining up the key in the shaft
with the keyway in the sprocket.
9.
Tap into place until the shaft seats.
10.
Install O-ring and oil seal in the hydraulic pump adapter.
11.
Install oil hydraulic pump adapter.
12.
Remove the bearing cover and install the O-ring, bearing lock washer and
locknut. Make sure the tang of the washer aligns with the keyway in the shaft.
13.
Tighten nut 1/4 turn from finger tight and bend one of the locking tangs on the
washer into one of the slots in the locknut.
14.
Tap locknut end of driven shaft towards oil seal housing to seat assembly.
15.
Install wave spring and bearing cover.
Driven Sprocket
Key
O-ring
Bearing Cover
Spacer
Bearing Lockwasher
Bearing Locknut
O-ring
Oil Seal
Hydraulic Pump
Adapter
