Waterous AQUIS ULTRAFLOW, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 217

15
|
217
Safety Introduction Product Overview Installation Operation Maintenance
AQUIS ULTRAFLOW Industrial Foam Proportioner System
Subsystem Subsystem Description Description
4 Concentrate pump These components support, control, and power the concentrate pump. The components in this subsystem include:
• Hydraulic concentrate pump—this circulates the foam concentrate through the system.
• Hydraulic motor—this drives the concentrate pump.
•
Hydraulic pump—this drives the hydraulic motor.
• Hydraulic ATF reservoir—this contains the hydraulic oil supply.
• Hydraulic ATF filter—this filters the hydraulic oil.
• Hydraulic ATF cooler—this cools the hydraulic oil.
• Hydraulic ATF temperature sensor—this monitors the hydraulic ATF temperature.
•
Hydraulic ATF level sensor—this monitors the hydraulic oil level in the reservoir.
• Pressure sensor—this monitors the pressure in the concentrate line.
• Pressure relief valve—this opens when the pressure in the line reaches a predetermined set-point.
5 Concentrate supply This contains components that contain or supply foam concentrate for the system. The components in this subsystem
include:
•
Foam concentrate supply tank—this contains the on-board foam concentrate supply.
• Tank-full sensor—this indicates a tank full condition to the system.
• Tank-low sensor—this indicates a tank low condition to the system.
• Tank level sensor—this is an installer supplied sensor and display that indicates the supply level in the tank.
• Concentrate pump intake select valve—this is an installer supplied, 2 position valve, and additional components that
sources concentrate from an on-board tank or an off-board supply. A signal is provided to the system to ignore the on-
board tank sensors when sourcing concentrate from an off-board supply .
• Concentrate strainer—this collects debris that would otherwise flow through the system.
6 Supply tank fill line This allows you to fill the on-board tank from an external source. The components in this subsystem include:
• Node controller—this connects to the fill valve and flowmeters.
• Fill line control valve—this controls the flow of concentrate.
• Magnetic flowmeter—this measures the flow of concentrate.
• CANbus splitter and cable—this connects the node controllers to one another
• Check valve—this prevents improper fluid flow in the line.