Assembly and Operating Instructions 'Basic' Pools
22
English
INSTALLING THE FLOOR PROTECTION
FLEECE AND THE BOTTOM RAILS
After the substrate has been prepared, spread out
the floor protection fleece (not part of delivery for
every pool). Either allow the edges to overlap (which
may be visible through the liner) or place the fleece
end-to-end and fix it from below with double-sided
adhesive tape. Then assemble the bottom rails by
plugging them into the connectors. Always start
with the bottom rail connectors on the steel girder.
The correct length of the bottom rails can only be
determined after the steel wall has been adjusted;
the bottom rails must be shortened accordingly, if
required.
Attention:
For figure-8 shaped pools,
we always deliver 2 complete sets of
bottom rails for the respective round
pool size (e.g. for a figure-8 shaped pool 470 x 300
cm, we deliver 2 sets of bottom rails 300 cm round),
so you always have a few segments left.
ASSEMBLING THE SEATS
Finally, screw the enclosed seats on top of the steel
girders:
STEEL WALL SETUP
INSTALLATION OF LINER
TOP RAIL & CONCRETE BACKFILLING
All further assembly steps and prescribed regulations
are the same as for round pools. Please continue reading
on page 15 of this manual.