CUBE
Manual
Page 65 - Revision: 5-24-2017
FILTER REPLACEMENT
Filters should be configured to optimize your system. Filters need to be configured and specified to
do the job given the local water conditions, usage, maintenance schedule, and placement
restrictions.
In order for our filters to perform as represented and to provide the best quality water possible, it is
essential that filters be replaced periodically. The frequency of filter changes depends on your water
quality and your water usage. For example, if there is a lot of sediment and/or particles in your
water, then you will have to change your filters more frequently than a location with little to no
sediment. Be sure to replace your filters whenever you notice a decline in the performance, whether
it is a drop in flow rate and/or pressure or an unusual taste in the water.
WARNING!
Read and understand the contents of this manual before attempting to service
CUBE. Failure to follow the instructions in this manual could result in death, serious personal
injury, or severe property damage. Only trained and qualified technicians should attempt to
install, maintain, or service Waterlogic Equipment.
Materials Needed:
•
Phillips Screwdriver.
•
Replacement filter cartridge(s)
•
Water Pitcher or Container to collect water from the faucet
•
5-gallon container or drain basin
19.
Turn off the incoming water supply at the isolation point.
20.
Select the cold-water icon and then select the dispense button. When the water
stops flowing release the button
21.
Switch Off the Red Power Switch and the Green Heater/Compressor switches at
the rear of the machine O=OFF and remove the power lead from the CUBE
Water Treatment System.
22.
Remove the two screws at the rear of the machine that hold the Top Cover in
place
